Category Archives: AirFree® Dispensing

It’s no secret that when using them for fluid dispensing, there is an erratic fluctuation of air supply that comes from compressors. This has resulted in numerous firefights to combat this common problem in the fluid dispensing industry. The fluid dispensing firefight process focused on the following components: Syringe and Piston Syringe and piston designs […]

Is your business using outdated fluid dispensing equipment? If so, you should consider making the switch to the newer technologies that are out there. Like leisure suits and disco, air-driven fluid dispensers are outdated relics from the 70’s that don’t belong in a 21st century manufacturing plant. You don’t want to be stuck in the […]

There are many benefits to using an AirFree® fluid dispensing system over an air driven system. Air driven fluid dispensing tends to be unpredictable, causing quality control problems. Over the lifetime of a system, an AirFree® fluid dispenser has a lower total cost of ownership than an air driven system because it brings the overall […]

Are you thinking of changing your fluid dispensing system? Consider switching to an air-driven dispensing system because it will help eliminate the problems associated with air driven fluid dispensers. Making the switch from an air-driven fluid dispensing system to an AirFree® fluid dispensing system allows you to enjoy these important benefits: Mitigated Risk There are […]

Fishman Corporation of Hopkinton, Massachusetts offers a full line of industrial polypropylene syringes. There are three colors and four different sizes. These syringes are used to dispense a wide range of light and viscous fluids. Please read on for more information about these syringes: About the Fishman Genius® AirFree® Polypropylene Syringes Fishman Genius® AirFree® Polypropylene […]

Pneumatic fluid dispensers or “time/pressure” dispensers were once the dominant means in delivering small quantities of adhesives and solder paste for electronics assembly. They are simple in design and consist primarily of a plunger, or piston, and a syringe. Pulsed air from a compressor “slaps” the top of the plunger in a rhythmic pattern moving […]

Manufacturers today consider much more than the initial purchase price of a piece of equipment before making an investment. They require their vendors to supply, not just an initial purchase price, but also a complete analysis of the cost of the equipment over time. Today’s savvy manufacturing companies know that the most important number to pay attention […]

Controlling the manufacturing process should concern all business. When processes are out of control, it causes costly disruptions in manufacturing. AirFree® Technology offers a solution for this because it brings the fluid dispensing process into control, and enable companies to manufacture a product the same way every time. Here’s more information about this: Limit Variation […]

Using the web, information can be sent to and from anywhere. This means that people can work remotely and don’t have to be in the office in order to be productive. In manufacturing, service technicians can assist in troubleshooting without actually being at the plant. Those that control and monitor a piece of equipment can […]

Cyanoacrylate, also known as “CA” or “super glue” has many uses; both consumer and commercial. It’s a popular adhesive because of its very short cure time and great bond strength. This “super” bond strength is possible without using heat or light curing or any type of catalysts. It is a substance that has many uses […]